4-1
Techniques of Sterilization Operator Manual 129390199
4.1 General The information in this section is intended as a general guide to
steam sterilization techniques. Also recommended is reference to
the standards of the ANSI/AAMI ST-79, Comprehensive Guide to
Steam Sterilization and Sterility Assurance in Health Care Facilities.
• Prior to sterilization, all materials and articles must be thoroughly
cleaned.
• After sterilization, goods should be stored in conditions that will
not compromise the barrier quality of their wrapping materials.
Training for all personnel on the operation and the maintenance of
the sterilizer shall be performed on a regular basis. Records of this
training and evidence of the understanding of the training material
shall be maintained, and are the responsibility of the organization or
facility where this equipment is in use.
Important: Applicable cycles have been validated to satisfy the
requirements outlined in Table 1 (page-ii) and Table 2 (page-iii). If
cycle parameters (sterilize time, dry time, temperature) other than
those listed are required, it is the responsibility of the healthcare
facility to consult and follow the device manufacturer’s written
instructions.
NOTE: Contact STERIS for information on a wide range of education/
training programs designed to meet the educational needs of
healthcare industries.
WARNING: It is inappropriate
for a healthcare facility to
sterilize liquids for direct
patient contact.
TECHNIQUES OF STERILIZATION
4
To Next Page
Loading...
