Anritsu MT8801C - Page 114

4-59
4.3 CDMA Transmitter and Receiver Test --- TX and RX Tester Mode
5. <Power Control Bit Pattern>
This sets the Power Control Bit Pattern.
Closed Loop: Performs power control of the TX level of the mobile station
to the desired value using the Closed Loop Power Control
Bit.
Alternate: Sets the power control bits to 0 or 1, alternately.
All 0: Sets all the power control bits to 0.
All 1: Sets all the power control bits to 1.
Auto: Performs the power control in real time operation.
The setting of this parameter is valid on all screens. This parameter can
also be specified using the function key on the Power Meter screen. (See
paragraph 4.3.6, (5).)
6. <User Define Level>
When the [User Define Level] function key is pressed on the Power Meter
screen, the TX level of the mobile station is set to this defined level using
the Power Control Bit.
• Function keys
Main function key: None
Function key: TX Parameter
[Back Screen] (F12): Displays the previous screen.