Section 4 Operation
4-66
• Main function keys
• Function keys:
Main function keys
1st page
[BS Output Level] F1: Sets the level of signal output from the MT8801C.
Initial value: –55.0 dBm
Setting range:–133.0 dBm to –18.0 dBm (RF Output: Main, AWGN Off)
–133.0 dBm to +2.0 dBm (RF Output: AUX, AWGN Off)
–133.0 dBm to –24.0 dBm (RF Output: Main, AWGN On)
–133.0 dBm to –4.0 dBm (RF Output: AUX, AWGN On)
Resolution: 0.1 dB
[Pilot Channel Level] F2: Sets the level of Pilot Channel output from the MT8801C.
Initial value: –7.0 dB
Setting range:–5.0 dB to –10.0 dB, 0 dB
Setting 0 dB at Pilot Channel can be performed only by GPIB
command. (See para. 2.5.8 of Remote Control volume of this
manual.)
Resolution: 0.1 dB
[Sync Channel Level] F3: Sets the level of Sync Channel output from the MT8801C.
Initial value: –16.0 dB
Setting range:–7.0 dB to –20.0 dB
Resolution: 0.1 dB
[Paging Channel Level] F4: Sets the level of Paging Channel output from the MT8801C.
Initial value: –12.0 dB
Setting range:–7.0 dB to –20.0 dB (Paging Data Rate: “Full”)
Resolution: 0.1 dB
[Traffic Channel Level] F5: Sets the level of Traffic Channel output from the MT8801C.
Initial value: –16.0 dB
Setting range:–7.0 dB to –20.0 dB (Data Rate: “Full”)
–10.0 dB to –23.0 dB (Data Rate: “1/2”)
–13.0 dB to –26.0 dB (Data Rate: “1/4”)
–16.0 dB to –29.0 dB (Data Rate: “1/8”)
Resolution: 0.1 dB
2nd page
[Channel] F1: Sets the Channel number.
Initial value: 1
Setting range:1 to 799, 900 to 1023 (Band: 800 MHz)
[Reference Level] F3: Sets the reference level of signal input to the MT8801C.
Initial value: 30 dBm
Setting range:42 dBm to –60 dBm (RF Input: Main)
22 dBm to –60 dBm (RF Input: AUX)
Resolution: 1 dB
To Next Page
Loading...
