Section 4 Operation
4-88
Function keys
1st page
[BS Level Step Up Ready] F7: Prepares the Step Up of the BS Output Level. (Initial state) (Note)
[BS Level Step Up Start] F7: Starts measurement with increasing the MT8801C BS Output Level by a Step value.
[BS Level Step Down Start] F8: Starts measurement with decreasing the MT8801C BS Output Level by a Step value.
(Initial state) (Note)
[BS Level Step Down Ready] F8:
Prepares the Step Down of the BS Output Level.
[Marker] F9: Displays the Marker menu.
[Normal] F7: Sets normal marker mode.
Sets the MT8801C to marker position input wait state.
Range: 0 to 100 ms
Resolution: 0.1
Initial value:
[Off] F8: Cancels marker mode and erases the displayed marker. (Initial value)
[return] F12: Returns to the previous menu.
[Calibration] F10: Displays the level calibration execution menu.
[Int. Osc. Calibration] F8: Executes level calibration using an internal oscillator.
During calibration, the window indicating that calibration is being executed is
displayed on the screen.
[Calibration Cancel] F9: Deletes level calibration data.
[return] F12: Returns to the previous menu.
[Back Screen] F12: Displays the previous screen.
2nd page
[Step Value] F7: Sets the step value to increase/decrease the BS Output level.
Range: 10 to 20 dB
Resolution: 0.1 dB
Initial value: 20.0 dB
[Back Screen] F12: Displays the previous screen.
Note:
Single key or Continuous key can start this measurement, where the Continu-
ous key forcibly makes the single operation.
To Next Page
Loading...
