4-109
4.3 CDMA Transmitter and Receiver Test --- TX and RX Tester Mode
The 2nd page of the main function keys on the Analog TX Meas with SG screen. (Call
Proc.: Conversation)
1
AF Level
RX RF
Level
MS Power
Level
Modulation Main Func
On Off
#
RX RF
Frequency
2
The 2nd page of the main function key on the Analog TX Meas with SG screen. (Call
Proc.: Stop)
Main Func
On Off
1
AF Level
RX RF
Level
RX RF Level
On Off
ModulationRX RF
Frequency
2
Note 1:
Relative values (RF Power and AF Level, which are always displayed) are
displayed with --.- dB until the [Set Relative] F8 key is pressed.
Note 2:
When RF measure mode is RF only mode on the Setup Analog TX Measure
Parameter screen, only RF Frequency and RF Power are measured.
Note that - is displayed for the measured values of Deviation and AF Level/
Distortion.
Note 3:
When the Call Proc. State is “conversation,” AF Osc.1 is used for SAT modu-
lation and it cannot be changed.
To Next Page
Loading...
