EasyManua.ls Logo

Anritsu MT8801C - Page 189

Anritsu MT8801C
493 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 4 Operation
4-134
• For Tone of signal type
0.400 V< Set value ≤ 3.000 V, 0.001 V step
40.0 mV< Set value ≤ 400.0 mV, 0.1 mV step
4.00 mV< Set value ≤ 40.00 mV, 0.01 mV step
0.010 mV< Set value ≤ 4.000 mV, 0.001 mV step
• For Noise of signal type
0.150 V< Set value ≤ 1.500 V, 0.001 V step
15.0 mV< Set value ≤ 150.0 mV, 0.1 mV step
1.50 mV< Set value ≤ 15.00 mV, 0.01 mV step
0.010 mV< Set value ≤ 1.500 mV, 0.001 mV step
When 50 Ω is set for Impedance of AF Output on the Setup Analog TX Measure
Parameter screen:
• For Tone of signal type
40.0 mV< Set value ≤ 300.0 mV, 0.1 mV step
4.00 mV< Set value ≤ 40.00 mV, 0.01 mV step
0.010 mV< Set value ≤ 4.000 mV, 0.001 mV step
• For Noise of signal type
15.0 mV< Set value ≤ 150.0 mV, 0.1 mV step
1.50 mV< Set value ≤ 15.00 mV, 0.01 mV step
0.010 mV< Set value ≤ 1.500 mV, 0.001 mV step
In Mod mode, this item disappears.
[AF Osc.2 On Off] F11 In Mod mode, turns on/off the FM deviation of SG by AF Osc. 2.
In AF mode, turns on/off the AF output.
(When off, the [AF Osc.2 Deviation] F9 key disappears, and deviation cannot be set.)
Initial value: Off
[Back Screen ] F12 Returns to the Setup Common Parameter screen.
Note:
When the unit key [dBµ/V] pressed, it is assumed as “dBµ” for RF level set-
ting, and as “V” for AF level setting.
3rd page ---- External input signal (from the Ext FM Input connector on the rear panel) is used for
FM modulation of the built-in signal generator (SG).
[External Deviation] F9 Sets FM deviation of signal generator using the External FM Input signal.
0.00 kHz ≤ FM Set value ≤ 40.00 kHz, 0.01 kHz step
Initial value: 8.00 kHz
[External On Off] F11 Turns on/off the External FM Input signal to turn on/off the FM deviation of signal
generator.
(When off, the [External Deviation] F9 key disappears, and deviation cannot be set.)
Initial value: Off
[Back Screen] F12 Returns to the Setup Common Parameter screen.

Table of Contents