4-151
4.3 CDMA Transmitter and Receiver Test --- TX and RX Tester Mode
4.3.14 Screen hard copy ... Copy
The copy function transfers a screen display to the printer or floppy disk. Specify a
transfer destination and mode on the Instrument Setup screen. Press the Copy key on
the front panel to activate the Copy function. While the Copy function is operating,
operations (including remote control) such as measurement or internal setting are dis-
abled.
(1) Transfer to the printer
If Copy is set to the printer on the Instrument Setup screen, screen display can be
printed via the Parallel interface on the rear panel. Printers using the ESC/P
command system can be used.
(2) Transfer to the floppy disk
If Copy is set to BMP on the Instrument Setup screen, the floppy disk driver on
the front panel can be used to store data displayed on the screen in the floppy
disk. Paragraph 4.3.10 describes the floppy disks that can be used. Data created
on the floppy disk is the image file of the monochrome BMP data format. While
the Copy is being executed, the name of the created file “RCA_***.BMP” is
displayed on the bottom of the screen (*** is a number beginning with 000).
(Reference) Number of storable BMP files
2DD (720 K bytes): Up to 18
2HD (1.44 M bytes):Up to 37
To Next Page
Loading...
