Anritsu MT8801C - Page 490

C-1
Appendix C Index
• The numbers on the right indicate section and paragraph numbers in this operation
manual.
ASCII code table .................................................................. Appendix A
Bit definition of END event status register ......................... 5.5.1
Bit definition of ERR event status register ......................... 5.5.2
Bit definition of standard event status register .................... 5.4.1
Bus initialization by the IFC statement ................................ 6.2
Character program data ........................................................ 4.2 (5), 4.3 (5)
Clearing the STB register by
the *CLS common command ............................................... 5.2.3 (4)
Connecting Devices with GPIB Cables ............................... 3.1
Connection ............................................................................ 3
Connection of RS-232C interface signal ............................. 3.3
Definition of MSS ................................................................ 5.2.3 (3)
Device initialization by PRE/INI/IP command .................... 6.5
Device initialization by the *RST command ....................... 6.4
Device message format ........................................................ 4
Device message list .............................................................. 2.5
Device messages ................................................................... 2
Device status at power-on .................................................... 6.6
Device-dependent summary messages ................................. 5.2.2
ESB and MAV summary messages ..................................... 5.2.1
ESB summary message ........................................................ 5.2.1 (1)
Example of system configuration using RS-232C/GPIB .... 1.3
Extended event status register .............................................. 5.5
Fetching screen ..................................................................... 8.1 (1)
GPIB instruction comparison table of the controller ........... Appdendix B
GPIB specifications .............................................................. 2.3
IEEE488.2 common commands
and supported commands ..................................................... 5.1
Initial setting ......................................................................... 6
Initialization for message exchange by DCL and SDC
statements ............................................................................. 6.3
INSTRUMENT SETUP command ...................................... 2.5.2
MAV summary messages ..................................................... 5.2.1 (2)
MT8801C common commands ............................................ 2.5.1
Notes on fetching the waveform data................................... 8.1
Overview .............................................................................. 1.1
Overview (device message) ................................................. 2.1
Overview (device message format) ...................................... 4.1
Program data ......................................................................... 4.2 (4)
Program message .................................................................. 4.2 (2)
Program message format ...................................................... 4.2