Anritsu MT8801C - Page 491

Appendix C
C-2
Program message terminator ................................................ 4.2 (1)
Program message unit .......................................................... 4.2 (3)
Query error details ................................................................ 5.4.2
Reading and clearing the STB register ................................ 5.2.3
Reading by the *STB common query .................................. 5.2.3 (2)
Reading by using serial polling ............................................ 5.3.3 (1)
Reading the SRE register ..................................................... 5.3 (1)
Reading, writing, and clearing
the extended event status enable register ............................. 5.5.4
Reading, writing, and clearing
the extended event status register ......................................... 5.5.3
Reading, writing to and clearing
the standard event status enable register .............................. 5.4.4
Reading, writing to and clearing
the standard event status register.......................................... 5.4.3
Remote control functions ..................................................... 1.2
Response data ....................................................................... 4.3 (4), 8.1 (2)
Response message ................................................................ 4.3(2)
Response message format .................................................... 4.3
Response message terminator .............................................. 4.3 (1)
Response message to input
the waveform data using binary data ................................... 4.3 (8)
Response message unit ......................................................... 4.3 (3)
Response wait by the status register .................................... 5.6.4
RS-232C specifications ........................................................ 1.4
RX tester command .............................................................. 2.5.6
Service request enable operation .......................................... 5.3
Service request wait by the status register ........................... 5.6.5
Setting RS-232C interface conditions .................................. 3.4
Setting the addresses ............................................................ 3.2
Setting the items relating to remote control
and panel key control ........................................................... 3.5
Setup Common Parameter command ................................... 2.5.4
Standard event status register ............................................... 5.4
Status byte (STB) register .................................................... 5.2
Status messages .................................................................... 2.4, 5
String program data .............................................................. 4.2 (7)
String response data.............................................................. 4.3 (7)
Suffix code ............................................................................ 2.2
Techniques for synchronizing
the MT8801C with a controller ............................................ 5.6
TX tester command .............................................................. 2.5.5
TX/RX tester command........................................................ 2.5.3
Updating the SRE register .................................................... 5.3 (1)