v
For Safety
CAUTION
1. Before Replacing the fuses, ALWAYS remove the power cord from the
poweroutlet and replace the blown fuses. ALWAYS use new fuses of
the type and rating specified on the fuse marking on the rear panel of
the cabinet.
T6.3A indicates a time-lag fuse.
T6.3A or F6.3A indicate a normal fusing type fuse.
There is risk of receiving a fatal electric shock if the fuses are replaced
with the power cord connected.
2. Keep the power supply and cooling fan free of dust.
• Clean the power inlet regularly. If dust accumulates around the
power pins, there is a risk of fire.
• Keep the cooling fan clean so that the ventilation holes are not ob-
structed. If the ventilation is obstructed, the cabinet may overheat
and catch fire.
3. Use two or more people to lift and move this equipment, or use a trolley.
There is a risk of back injury, if this equipment is lifted by one person.
4. Never input a signal of more than the specified voltage between the
measured terminal and ground. Input of an excessive signal may dam-
age the equipment.
5. Do not take out the floppy disk if the lamp of the floppy disk drive is on.
If it is taken out, the contents of the storage medium will be damaged,
resulting in floppy disk drive failure.
Replacing Fuse
CAUTION
Cleaning
Check Terminal
To Next Page
Loading...
