vi
For Safety
CAUTION
The power for memory back-up of the MT8801C is supplied by a poly-
carbomonofluoride lithium battery. this battery should only be replaced by
a battery of the same type; since replacement can only be made by Anritsu,
contact the nearest Anritsu representative when replacement is required.
At the end of it's life, the battery should be recycled or disposed properly.
Note: The Battery life is about 7 years. Early battery replacement is rec-
ommended.
The MT8801C stores data and programs using a floppy disk (FD), memory
card (MC), and backed-up memories.
Data and programs may be lost due to improper use or failure.
Anritsu therefore recommends that you back up the memory.
ANRITSU CANNOT COMPENSATE FOR ANY MEMORY LOSS.
Please pay careful attention to the following points. Do not remove the
floppy disk from the equipment being accessed.
(FD)
• Do not touch the FD directly or by using any object.
• Do not place the equipment where dirty and dusty.
• Isolate the FD and memory card from static electricity.
• Avoid to placing the FD in direct sunlight or near heating sources.
• Store under temperature of 40˚ to 54˚C, humidity of 8 to 90%
(No condensation).
(Memory card)
• Isolate the memory card from static electricity.
(Backed-up memory)
• Isolate the memory from static electricity.
The MT8801C uses chemical compound semiconductor including arsenic.
At the end of its life, the MT8801C should be recycled or disposed properly
according to the local disposal regulations.
Replacing Memory
Back-up Battery
External
Storage Media
Disposing of Product