4-23
4.3 CDMA Transmitter and Receiver Test --- TX and RX Tester Mode
Notes:
1. When the Adjust Range and Calibration are performed in any TX measure-
ment screen, the compensation data is valid in any other TX measurement
screens.
2. If the MT8801C input level is small or the input frequency does not match
the setup frequency, the Adjust Range and Calibration may not be per-
formed properly.
3. Execute Adjust Range and Calibration while the measurement signals are
input stationary.
4. When performing Calibration results in an error (corrected data cannot be
generated), calibration factor of the Calibration (held before the execution)
is lost.
To Next Page
Loading...
