4-31
4.3 CDMA Transmitter and Receiver Test --- TX and RX Tester Mode
• Changing the time and date of the built-in clock
1. Changing the date
Step Key operation Description
1. [Date] F7 Opens the date setting window.
Displays the current date and time of the built-in clock.
2. Cursor [ ] [ ] Moves the cursor to the part to be changed.
3. 0 to 9, [BS] Sets the data.
4. Cursor [ ] [ ] Moves the cursor to the next part to be changed.
5. 0 to 9, [BS] Sets the data.
6. [Set] Closes the setting window and establishes the set value.
2. Changing the time
Step Key operation Description
1. [Time] F8 Opens the time setting window.
Displays the current time of the built-in clock.
2. Cursor [ ] [ ] Moves the cursor to the part to be changed.
3. 0 to 9, [BS] Sets the data.
4. Cursor [ ] [ ] Moves the cursor to the next part to be changed.
5. 0 to 9, [BS] Sets the data.
6. [Set] Closes the setting window and establishes the set value.
Note:
To stop changing the date or time of the built-in clock
To stop changing the date or time after opening the setting window of the built-
in clock, press the [Cancel] key in the above Step 4 or 5 (do not use the [Set]
key). If the [Set] key is pressed again after the date and time window is
opened, the value on the setting window is set again. The date and time win-
dow remains in the state when the window was opened. Therefore, if the [Set]
key is pressed without changing the display on the window, the date and time
of the built-in clock are delayed.
To Next Page
Loading...
