Anritsu MT8801C - Page 85

Section 4 Operation
4-30
• Selecting Power On Initial mode
The following describes how to select parameter initialization mode after power-on.
1. Selecting Previous Status mode
Step Operation
1. Press the [Power On Initial] F9 key.
2. Press the [Previous Status] F7 key.
3. Press the [return] F12 key to define the parameters then return to the previous menu.
2. Selecting Recall File mode (being developed)
Step Operation
1. Press the [Power On Initial] F9 key.
2. Press the [Recall File] F8 key. (Access the floppy disk to call the parameter list file.)
3. Press the [File No.] F9 key. (Open the parameter-file setting-location [number] window.)
4. Enter the number of the parameter file to be set.
5. Press the [Set] key to define the parameters, then press the [return] F12 key to return to the previous
menu.
6. Set the floppy disk (on which parameters to be read before power-on are written) in the floppy disk
drive.
When the next power on, the parameters in floppy disk is set.
Notes:
• If no floppy disk is set before power-on or a floppy disk other than that used
at setting is used, parameters may be set in Previous Status mode or differ-
ent parameters may be set.
• The ambient temperature range of the floppy disk is specified as 5 to 45°C.
If a set temperature is outside the specified range, operation is not guaran-
teed.