AOR AR5001D - 6 MEMORY CHANNELS AND BANKS; 6-1 MEMORY CHANNEL OVERVIEW; 6-2 STORING VFO FREQUENCIES AND DATA INTO MEMORY

18
8 - ALARM
Figure EIGHT for the numeric input of frequencies, bank, channel numbers, etc.
Press the [FUNC] key, and press the [8] key to activate the alarm function which automatically turns on
the receiver at the preprogrammed time or sound a beep.
9 - SLEEP
Figure NINE for the numeric input of frequencies, bank, channel numbers, etc.
Press the [FUNC] key, and press the [9] key to activate the sleep function to turn the receiver off
automatically at the preprogrammed time.
0 - OPTION
Figure ZERO for the numeric input of frequencies, bank, channel numbers, etc .
Press the [FUNC] key, and press the [0] key to activate the option menu.
. - DELETE
Use during the MHz frequency input to separate the MHz from the res t of the entry of kHz and Hz.
For example, the entry of 88.300000 MHz would be [8][8][.][3] [MHz].
Note: Frequen cies below 3.0 MHz (3000 kHz) are always displayed as kHz regardless of input format.
In memory mode, press the [FUNC] key, and press the [.] to display the memory channel to be deleted.
Press the [FUNC] key, and then press and hold the [.] key for two seconds to activate the delete menu.
kHz – CONFIG/SD
The [kHz] key is used to accept frequency input from the numeric keypad in kHz format.
For example, entering of 954 kHz, press [9][5][4][kHz]. The LCD will display 954.000 k Hz.
Note: Entering a decimal [.] before the number will result a preceding zero to be added automatically.
Press the [FUNC] key, and press the [kHz] key to activate the configuration menu.
Press the [kHz] while an SD memory card is inserted to activate the audio playback function.
Usin g the [UP] key or [DOWN] key to select the recorded file, press the [MHz] key to playback audio. To
stop playback, press the [CLR] key.