Prepare and load sample plates
Prepare sample plates as needed for your application. Refer to the following topics to
help you determine sample placement in wells.
• “Default injection positions—48-capillary arrays“ on page 37
• “Default injection positions—96-capillary arrays“ on page 39
• “Default injection order on plates“ on page 59
1.
Briey centrifuge the plate.
2.
Ensure that each sample is positioned correctly in the boom of its well.
IMPORTANT! If the contents of any w
ell contain bubbles or are not located at the
boom of the well, briey centrifuge the plate, remove the plate from the
centrifuge, and verify that each sample is positioned correctly in the boom of its
well.
3.
Store the plate on ice and protected from light until y
ou prepare the plate
assembly and load the plate in the instrument.
After you load samples in plates, see “Seal and assemble plates“ on page 41.
Default injection positions—48-capillary arrays
2 injections are required to sample all wells on the plate.
Injection 1
Injection 2
96-Well plate,
48 c
apillaries
Chapter 2 Pr
epare the instrument
Prepare and load sample plates
2
3730xl DNA Analyzer with 3730xl Data Collection Software 5 User Guide
37
To Next Page
Loading...
Need help?
General
