EasyManua.ls Logo

AudioCodes Media Pack MP-124 - Page 342

AudioCodes Media Pack MP-124
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SIP User's Manual 342 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
Source Phone Number Manipulation
Table for Tel to IP Calls
This
[SourceNumberMapTel2IP]
ini
[SourceNumberMapTel2Ip]
FORMAT SourceNumberMapTel2Ip_
file table parameter manipulates the source phone
number for Tel-to-IP calls. The format of this parameter is
as follows:
Index =
SourceNumberMapTel2Ip_DestinationPrefix,
SourceNumberMapTel2Ip_SourcePrefix,
SourceNumberMapTel2Ip_SourceAddress,
SourceNumberMapTel2Ip_NumberType,
SourceNumberMapTel2Ip_NumberPlan,
SourceNumberMapTel2Ip_RemoveFromLeft,
SourceNumberMapTel2Ip_RemoveFromRight,
SourceNumberMapTel2Ip_LeaveFromRight,
SourceNumberMapTel2Ip_Prefix2Add,
SourceNumberMapTel2Ip_Suffix2Add,
SourceNumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID,
NumberMapTel2Ip_SrcIPGroupID
For example:
[SourceNumberMapTel2Ip]
SourceNumberMapTel2Ip 0 =
22,03,$$,0,0,$$,2,$$,667,$$,0,$$,$$;
SourceNumberMapTel2Ip 0 =
10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
[\SourceNumberMapTel2Ip]
;
[\SourceNumberMapTel2Ip]
This table parameter can include up to
Notes:
20
indices.
RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add, LeaveFromRight, NumberType,
NumberPlan, and IsPresentationRestricted are applied
if the called and calling numbers match the
DestinationPrefix and SourcePrefix conditions.
The parameters
SourceNumberMapTel2Ip_NumberType,
SourceNumberMapTel2Ip_NumberPlan are not
applicable. Set these to $$.
The manipulation rules are executed in the following
order: RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and Suffix2Add.
Parameters can be skipped by using two dollar signs
('$$').
An asterisk ('*') represents all IP addresses.
IsPresentationRestricted is set to 'Restricted' only if
'Asserted Identity Mode' is set to 'P-Asserted'.
To configure manipulation of source numbers for Tel-to-
IP calls using the Web interface, refer to ''Configuring
the Number Manipulation Tables'' 124 on page ).
For a description on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' 191 on page .
Source Phone Number Manipulation
Table for IP to Tel Calls
This ini file table parameter manipulates the source
number for IP-to-Tel calls. The format of this parameter is

Table of Contents

Related product manuals