AvL Proprietary and Confidential
Content is Subject to Change without Notice Page 183 of 195
"Ref. Satellites Failed, Calibrating Heading"
"Moving to target satellite"
"Cannot execute command while alarm is active."
"GPS Coordinates are not valid."
"GPS or compass is in Alarm state."
"Modem has not sent a target."
"All signal sources tried with no valid signal
detected."
"Scanning will exceed Az Limits - Rotate Base and
try again"
"Heading calibration failed. No signal found during
arc scan."
"Command failed. Home must be run first."
"Elevation inclinometer failure."
"Azimuth must be on stow switch"
"Invalid operation for the current hardware."
"Invalid signal for peaking."
"Invalid target for this location."
"Could not transform world coordinates."
"Acquire failed waiting for modem/beacon signal."
"Elevation deploy failed."
"Heading calibration Failed. No signal found during
scan for a reference satellite."
"The crosspol command cannot be performed with
this feed."
"Unable to Calculate Heading
"Heading calibration completed"
"Cross Pol (H/V) POL move complete"
"Position hold completed."
"Command skipped due to hardware
configuration."
"Idle waiting for next command"
"Elevation deploy completed"
"Elevation stow completed"
"Scan for reference satellite completed"
"Module command completed"
"Mount reflector and select OK to continue"
"Unmount reflector and select OK to continue"
To Next Page
Loading...
Need help?
General