Barco SIM 5W - List of Images List of Images; List of Images

List of images
LIST OF IMAGES
3-1 Roll possibilities ...................................................................................................... 11
3-2 Pitch possibilities .....................................................................................................12
3-3 Side projection limitations............................................................................................12
3-4 Air intake vent ........................................................................................................13
4-3 Make sure the lens lock holder is in the left position. ...............................................................18
4-5 The female jack on the lens (A) must be in front of the male jack (B) located in the upper-left part of the housing in
the projector...........................................................................................................19
4-6 In case of a Scheimpflug lens, insert the lens with the adjustment bolts located in the left and bottom position. . . 19
4-7 The lens lock handle is located on the front side of the projector, slide this handle to the right. . . . . . . ............ 20
4-8 %off-axis: Defining the distance to measure the %off-axis .. ......................................................22
4-9 Safe shift range based on the maximum up/down, left/right directions.............................................22
4-12 Connections overview................................................................................................25
4-13 Composite video connection . ........................................................................................26
4-14 S-Video connection...................................................................................................26
4-15 RGB connections. . . ..................................................................................................27
4-16 Component video connection ........................................................................................28
4-17 DVI input connection ................................................................................................. 29
4-18 DVI input connection ................................................................................................. 29
4-19 DVI HDCP input connection . ........................................................................................30
4-20 DVI out connection . ..................................................................................................30
4-21 PC connection ........................................................................................................31
4-22 Network connection ..................................................................................................32
4-27 Serial connection . . . ..................................................................................................35
4-28 RCU Overview........................................................................................................36
4-29 Local Keypad Overview.............................................................................................. 37
4-30 Diagnose Leds .......................................................................................................38
7-20 Common non- anamorphic aspect ratios in (non-HDTV) DVD sources ............................................64
7-21 Anamorphic aspect ratios in (non-HDTV) DVD sources ............................................................64
7-22 Aspect ratios in native HDTV DVD sources.........................................................................64
7-23 Aspect ratio for WUXGA (1920x1200)...............................................................................65
7-57 Geometry file notation................................................................................................81
7-59 The screen is divided in 33x33 regions..............................................................................82
7-60 Geometry levels......................................................................................................83
7-61 Geometry level hierarchy ............................................................................................84
7-67 Busy message........................................................................................................88
7-71 2x2 Adjustment points................................................................................................90
7-94 Geometry: Shift......................................................................................................102
7-95 Transport delay......................................................................................................103
7-96 Transport Delay basic principle .....................................................................................103
7-103 Geometry Restore example : restoring to a 9x9 level .............................................................107
7-154 The CIE chromaticity diagram ......................................................................................133
7-155 The projector color gamut is defined by the triangle formed by the x, y coordinates of Red Green and Blue .. .134
7-156 The color gamut of each projector will differ.......................................................................134
7-157 Common Color Gamut ..............................................................................................134
7-158 The Common Color Gamut .........................................................................................135
7-169 Soft edge : purpose .................................................................................................145
7-170 Soft Edge Basic Principle ...........................................................................................145
7-171 Soft edge : adjustment points.......................................................................................146
7-172 Soft edge : points numbering, Top and bottom side edges ........................................................147
7-173 Soft edge : points numbering, left and right side edges ...........................................................147
7-174 Side Soft edge zone: levels. . .......................................................................................148
7-175 Soft edge : Level hierarchy .........................................................................................148
7-198 Black level : double brightness compensation . . ...................................................................161
7-209 Outline ...............................................................................................................167
7-210 Hatch.................................................................................................................167
7-211 Color bars............................................................................................................167
7-212 Checkerboard .......................................................................................................168
7-213 HGBWS..............................................................................................................168
7-214 H pattern.............................................................................................................168
7-215 Convergence ........................................................................................................168
7-216 Purity.................................................................................................................169
7-218 Scaled patterns : Geometry.........................................................................................170
7-219 Scaled patterns : Gray levels .......................................................................................170
7-220 Scaled patterns : Stereo pattern....................................................................................170
7-237 Press the double right arrow key until the dimmer appears on the top edge of the screen. ......................179
7-238 Use the fine adjustment buttons to move the dimmer back until it is no longer visible ...........................179
7-240 Press the double right arrow key until the dimmer appears on the bottom edge of the screen ..................180
7-241 Use the fine adjustment buttons to move the dimmer back until it is no longer visible ...........................180
R59770324 SIM 5W 22/12/2011
191
Downloaded From projector-manual.com Barco Manuals