7. Advanced
Field
/adjustment
Description Notes
Colom column corresponding to the selected point in a 2x2 adjustment column will be between 0
and 32 (steps of 32)
Row row corresponding to the selected point in a 2x2 adjustment row will be between 0 and
32 (steps of 32)
PixelX this slider box adjusts the new position of the point along
the x axis
High values can introduce some clipping
effects
PixelY
this slider box adjusts the new position of the point along
the y axis
High values can introduce some clipping
effects
edit box PixelX
this edit box allows to edit the position of the point along
the x axis
edit box PixelY this edit box allows to edit the position of the point along
the y axis
Axislink see ’Axislink’
Modes
see ’Geometry Edit Modes’
Table 7 -2
dialog box legend
When applying a distortion to the image this may take a certain time. During this operation, a text box is
shown.
Busy
Image 7-67
Busy message
7.6.6.3 Geometry Edit Modes
The geometry Edit Modes
• Select mode : allows to select the desired area on the screen using the arrows. From 0 to 32 along the x and y axis.
• Adjust mode : allows to perform the correction (in real time) using the arrows. The adjustment is done in small steps of 0.1
pixels.
• Edit mode : allows to select the desired control (edit box, ...) in the dialog box.
• Change mode : allows to change the values in the controls (edit box, radio buttons, ...) of the dialog box.
88
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
