7. Advanced
Image 7-221
5. Press → to Pull down the menu
6. Use ↑ or ↓ to select the desired pattern
7. Press ENTER
The active selection is indicated with a white bullet
7.10.4 Formatter patterns
Overview
Unlike the Internal patterns, the Formatter patterns will be distorted according to the active Geometry File.
•Grid
• Horizontal ramp
•Verticalramp
• Horizontal lines
• Vertical lines
• TI checkerboard
• Checkerboard
How to select an Formatter pattern ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation menu
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Formatter Patterns
R59770324 SIM 5W 22/12/2011
171
Downloaded From projector-manual.com Barco Manuals
To Next Page