Barco SIM 5W - Battery Installation in the RCU

4. Installation
Length with different lenses : see table
Cold air IN
Cold air IN
69
20
Cold air OUT
415
487 (length without Cable Basket)
45
78
305
281
152
380
195
Image 4-1
4.1 Battery installation in the RCU
How to install the battery
Two batteries are packed together with the RCU. Before using your RCU, install first these batteries.
1. Remove the battery cover on the backside by pushing the handle a little towards the bottom of the RCU.
2. Lift up the top side of the cover at the same time.
3. Insert the batteries as indicated in the RCU.
4. Put the battery cover on its place.
How to replace the batteries in the RCU
To replace the batteries :
1. Remove the battery cover on
the backside by pushing the handle a little towards the bottom of the RCU.
2. Lift up the top side of the cover at the same time.
3. Push on the + side of the battery towards the - side
4. Lift up the battery at the same time.
16
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals