7. Advanced
Image 7-203
7. Press ENTER
The soft edge dialog box will be displayed.
8. Uncheck all the edges
9. Adjust the soft edge as desired (same procedure as above)
10.Press BACK to return to the Display setup menu.
7.9.10 AutoImage Setup
What can be done ?
AutoImage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the display.
AutoImage can adapt the image based on following data :
• Total pixels/ lines
• Start pixel/lines
•Phase
• Contrast/brightness levels
AutoImage works only for data signals.
To launch Autoimage, see AutoImage in the Image files menu
How to set up AutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select AutoImage setup
164
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
