4. Installation
• 3 for the color signals R,G,B
• 2 for the sync signals H (horizontal sync), V (vertical sync)
RGBS : If the source disposes of a composite sync output i.e. one wire includes the horizontal and the vertical sync then the V BNC
must not be connected, resulting in 4 BNC being connected (V is free).
RG
s
B : If the source disposes of a sync on Green output (i.e. the Green color signal includes the horizontal and the vertical sync),
then the H and V BNC’s must not be connected, resulting in 3 BNC being connected (H and V are free).
BNC Connector
RGBHV
RGBHV R G B H V
RG
s
BRG
s
B
--
RGBS R G B S
-
Table 4 -6
How to use the BNC’s in case of different RGB signals
The RGB 5 BNC input can also be used to connect a component video source : see Connecting a Component
video source.
How to connect an RGB signal ?
1. Connect the 5 or 4 BNC cables to the projector’s RGB input
Projector
DVI-D COMPUTER
DVI-D HDCP COMPUTER
Image 4-15
RGB connections
4.9.6 Component video
Component video connection
A component video signal is available can also be mentioned in the following way:
•YUV
•PrYPb
• (R-Y) Y (B-Y)
How to connect a component video signal?
1. Connect the 3 BNC cables to the projectors Pr Y Pb input.
R59770324 SIM 5W 22/12/2011
27
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
