7. Advanced
7.5.3 Forced file load
Forced file load
In some cases the user wants only one particular file to be loaded for a particular input (source) i.e. to prevent the (automatic) load
of an inadequate file.
One can link a file to every input of each layer.
If a file is already selected (forced) to that particular input it will be indicated in the menu.
How to force a file to be loaded ?
1. Press MENU to activate the Tool bar
2. Press → to select the Image files item
3. Press ↓ to Pull down the Image files menu
4. Use ↑ or ↓ to select Forced file load
5. Press → to open the menu
6. Use ↑ or ↓ to select the desired layer (for example Layer 1)
7. Press → to open the menu
8. Use ↑ or ↓ to select the desired input
Image 7-41
Note: Inputs that are not hardware compatible with this layer are greyed out.
Note: if a file is already forced for that input it will be shown on the right.
9. Press ENTER
The Loa d dialog box is displayed
10.Use ↑ or ↓ to select the desired file (for example /Standard/SXGA+@60.xml)
11. Press ENTER
The file is selected and will be loaded in the future.
To delete the forced file, go to the desired input and press ENTER.
74 R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
