7. Advanced
Image 7-197
Note: It will take a cer tain time for the alpha plane to be applied
7.9.9.5 Black level
Overview
• Introduction
• Internal black level
• Beta planes
7.9.9.5.1 Introduction
Brightness uniformity
In a multi channel system the brightness can vary over the different channels/projectors. The brightness level can be matched using
:
1. CLO: in this case the light power is matched over the different projectors, see CLO in the Lam ps section
2. Black level : this will act on the brightness of the “black” color of the image part situated outside the soft edge zones.
Internal black level versus Beta Planes
In the same way as for the soft edge adjustment (Internal vs Alpha planes) this black level adjustment can be fixed internally by
using a dialog box or externally by uploading a u
ser defined Beta plane. This beta plane will contain the values for the brightness
offset to be applied to the image.
Both methods will allow to compensate for the typical double brightness phenomenon in the soft edge zones by increasing the
brightness of the rest of the image.
160
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
