Barco SIM 5W - CLO Target in Infitec

7. Advanced
Image 7-118
9. Press ENTER
A dialog box is displayed
Image 7-119
10.Use ←or →, the numeric keys on the remote, or the keypad to change the target value.
Note: Range: 200 to 5000 A.U.
7.7.3.3.2 CLO target in Infitec
TM
mode
How to set the CLO target in Infitec
TM
mode ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamps item
3. Press ↓ to pull down the Lam ps menu
4. Use ↑ or ↓ to select CLO
5. Press → to pull down the CLO menu
6. Use ↑ or ↓ to select Targ e ts
7. Press → to pull down the Targets menu
8. Use ↑ or ↓ to select Infitec Mode...
Image 7-120
9. Press ENTER
116
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals