7. Advanced
7.5.2 Load file
When to load a file ?
In some cases the user wants a particular file to be used for the display of a particular source. In this case the user should load the
desired file from the image files menu. The load file option will allow the user to choose between several files corresponding more
or less to the active source specifications.
In normal operation the file selection (load) will be done automatically by Auto Image.
Howtoloadafile ?
1. Press MENU to activate the Tool bar
2. Press → to select the Image files item
3. Press ↓ to Pull down the Image files menu
4. Use ↑ or ↓ to select Load
Image 7-39
5. Press ENTER
A dialog box is displayed
Image 7-40
6. Use ↑ or ↓ to select the desired file
Tip: For more information (specifications) on the image files see the Appendix section
7. Press ENTER
The file is loaded and the image is adapted.
What to do if the image is not perfect ?
If the displayed image is not correct after Auto Image or after selecting the best fitting file, go to the Edit menu, select the active file
and change the settings.
R59770324 SIM 5W 22/12/2011
73
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
