7. Advanced
6. Use ↑ or ↓ to select Enable
7. Press → to open the menu
8. Use ↑ or ↓ to select ON
Image 7-160
9. Press ENTER
A white point shows the active setting
7.9.6.3 DynaColor sets
What can be done ?
2 sets of Dynacolor adjustments can be defined and selected. In the following procedures we will only use set1.
How to select a Dynacolor set ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Dynacolor
5. Press → to open the menu
6. Use ↑ or ↓ to select Active Set
7. Press → to open the menu
8. Use ↑ or ↓ to select for example Set1
Image 7-161
9. Press ENTER
138
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page