4. Installation
18
BACK To leave the selected menu or item (go upwards to previous menu)
19
RCU operation
indication led
Lights up when a button on the remote control is pressed. (This is a visual indicator to check
the operation of the remote control)
4.11 Local Keypad Terminology Overview
What keys can be found on the Local Keypad?
19
20
21
22
23
24
25
Local Keypad
SOURCE
LENS
Image 4-29
Local Keypad Overview
The following table gives an overview of the different functionalities of the keys that can be found on the Local Keypad:
19 Cursor keys To make menu selections, to perform bare scale adjustments or to zoom/focus when the direct
access is active
20 ENTER
To start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode
21
BACK To leave the selected menu or item (go upwards to previous menu)
22
SOURCE
Not used
23 Lens control
Use these buttons to obtain the desired ZOOM, SHIFT and FOCUS
24
STANDBY Standby button, to start projector when the power switch is switched on and to switch off the
projector without switchi
ng off the power switch
Attention : Switching to Standby. When the projector is running and you want to go to
standby, press the standby key for 2 seconds.
25 IR Receiver IR Receiver
R59770324 SIM 5W 22/12/2011 37
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
