Barco SIM 5W - Connecting to a DVI Connector; DVI; Introduction; Component Video Connection

4. Installation
Projector
DVI-D COMPUTER
DVI-D HDCP COMPUTER
Image 4-16
Component video connection
4.9.7 DVI
Overview
• Introduction
• Connecting to a DVI connector
4.9.7.1 Introduction
DVI IN
By default 2 DVI-D connectors are available to connect DVI sources to the projector.
DVI HDCP IN
By default one DVI HDCP input is available. The content of this signal can be displayed by this projector, but since this is a protected
signal, it will not be visible through the DVI out connector.
DVI OUT
This DVI output has the same resolution as the native resolution of the projector (1920x1200) with a vertical refresh rate of 60Hz.
This can not be changed.
In case of a selected DVI HDCP source, this DVI out will show a black window, not the content of the signal.
4.9.7.2 Connecting to a DVI connector
How to connect a DVI source?
1. Connect the DVI cable to the DVI IN connector of the projector.
28
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals