Barco SIM 5W - Communications; Network Connections; PC Connection

4. Installation
Projector
DVI-D COMPUTER
DVI-D HDCP COMPUTER
Image 4-21
PC connection
4.9.9 Communications
4.9.9.1 Network connections
What can be done ?
The projector can be connected to a network allowing it to be accessed from any connected network device. The Ethernet connec-
tion can be used to upload/download projector software and/or to set up communication (TCP/IP protocol) with the projector. This
network can be a local area network or a small dedicated network
Following operations are made possible :
• file transfer for firmware upgrade
• easy adjustment of projector
• storage of multiple projector configurations and set ups.
• wide range of control possibilities.
• linking the projectors to allow uniform color (
Linked Dynacolor) and brightness (CLO) ,...
•...
The connection to the projector can be done via a crossed cable or via a HUB on the local network (LAN).
How to connect the projector ?
1. Connect the RJ 45 male plug to the projector’s RJ 45 female connector
R59770324 SIM 5W 22/12/2011
31
Downloaded From projector-manual.com Barco Manuals