7. Advanced
A textbox is displayed
Image 7-113
7.7.2 Lamp mode
What are the different lamp modes ?
Single mode
The projector will always switch to the lamp with the shortest runtime when the difference between the runtimes of lamp1 and lamp
2 reaches 100 hours, switching from one lamp to another happens only at switching on of the projector and not during operation.
When the lamp fails or reaches its maximum runtime the projector switches automatically to the other lamp without interrupting the
projection.The failure is logged and the lamp will never be initialized in the future.
Dual mode
Both lamps are working.
When one lamp fails, the projector continues the projection using th
e remaining lamp.
How to select the lamp mode ?
1. Press MENU to activate the Toolbar
2. Press → to select the Lamp item
3. Press ↓ to Pull down the Lamp menu
4. Use ↑ or ↓ to select Mode
5. Press → to pull down the menu
6. Use ↑ or ↓ to select the desired mode
Image 7-114
7. Press ENTER
A bullet shows the active mode.
112
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
