7. Advanced
Image 7-97
The Transport Delay dialog box will be displayed.
Image 7-98
3. Push the cursor key ↑ or ↓ to select the radio buttons
4. Press ENTER to check the desired radio button
5. Press BACK to return to the G eom etry Edit menu.
How to adjust the Transport Delay manually?
1. Display the Transport Delay dialog box (see procedure above)
Image 7-99
2. Use the cursor key ← or → , the numeric keys on the RCU, or the local keypad, to edit and change the value of the Transport
Delay.
Note: The Transport Delay is by default set to 200.
The Tr ansport Delay Range can be se
t from 0 to 1023.
Tip: When the transport delay needs to be adjusted In a m ulti channel setup, fir st adjust the transport delay of all projectors
one by one, leave the projector w ith the maximu m value, then set all other projectors to this maximum value.
3. Press BACK to return to the G eom etry Edit menu.
7.6.6.8 Sharpness
What can be done ?
In some extreme warping conditions digital noise may appear in the warped regions. The sharpness adjustment in the Geometry
menu allows to get rid of these perturbations.
104
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
