7. Advanced
5. Press ENTER
A dialog box is displayed
Image 7-62
6. Use the cursor key ↑ and ↓ to select the desired geometry file
7. Press ENTER
Tip: When starting a new geometry s etup it is advised to select the “No_Distortion” file.
The file is loaded and the geometry settings are adapted.
7.6.6 Edit
The images below show adjustments performed on a hatch pattern generated internally by the projector (see
internal patterns).
Overview
• Accessing the Geometry Edit menu
• Geometry Edit wizard
• Geometry Edit Modes
• Editing a geometry file
•Axislink
• Shift Adjustment
• Transport Delay
• Sharpness
• Geometry Reset
7.6.6.1 Accessing the Geometry Edit menu
How to access the Geometry Edit menu ?
1. Press MENU to activate the Tool bar
2. Press → to select Geometry
3. Press ↓ to Pull down the Geometry menu
4. Press ↓or ↑ to select Edit
5. Press → to open the Edit menu
R59770324 SIM 5W 22/12/2011
85
Downloaded From projector-manual.com Barco Manuals
To Next Page