7. Advanced
4. Press ENTER to confirm your choice
A bullet indicates the selected composite video source which now appears on the screen.
7.3.4 RGB-YUV
When
Select RGB-YUV when in presence of a data signal of the type RGB+ sync connected to the RGB input (5 BNC’s) or a c
omponent
signal of the type (R-Y)/Y/(B-Y).
These signals are often available on a VGA D15 connector of a PC or another image generator.
An RGB data signal can have its sync signal added in different ways, refer to the Installation section for more
information on the RGB+sync signals accepted by the RGB input.
How to select the RGB input ?
1. Press MENU to activate the Tool bar
2. Press ↓ to Pull down the Source Selection menu
The menu will contain one menu Lx RGB-YUV , x being the layer on which the RGB signal is connected (for example L1 RGB-YUV
if the signal is connected to layer 1).
3. Use ↑ or ↓ to select Lx RG B-YUV
4. Use → to open the menu
5. Use ↑ or ↓ to select RGB or YUV
Image 7-6
6. Press ENTER to confirm your choice
A bullet indicates the selected source which now appears on the screen.
Adjustments on an RGB signal
The projector allows different adjustments on an RGB signal :
• Contrast
• Brightness
•Phase
• Input balance
• AutoImage : or manual edit of the image file settings
7.3.5 PC
When
Select PC when you are in presence of a data signal of the RGB + sync form connected to the D15 input connector of the projector.
An RGB data signal can have its sync signal added in different ways, refer to the Installation section for more
information on the RGB+sync signals accepted by the PC input.
R59770324 SIM 5W 22/12/2011 57
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
