Barco SIM 5W - RCU Terminology Overview; RCU Overview

4. Installation
4.10 RCU Terminology Overview
What keys can be found on the RCU?
F1
F2
F3
MENU BACK
ENTER
PAUSE
AU TO IMAG E
PCRGB
VIDEO
Fire Wire
DVI
IQ-PC SDI
S-VIDEO
LOGO
PHASE
PIP
TINT
COLOR
BRIGHT N
CONTR
FOCUS
LENS
ZOOM
LENS
ZOOM
DIGI
SHIFT
LENS
VOL
9
0
7
8
56
34
1
2
1
2
3
4
5
6
7
8
9
10
19
18
17
16
15
14
13
11
12
Image 4-28
RCU Overview
The following table gives an overview of the different functionalities of the keys that can be found on the RCU:
1 Function keys Not used
2 MENU Menu key, to enter or exit the Toolbar menu
3 Address key (Recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9
4
LOGO Switch between displaying the internal or external pattern in the Geometry Distortion and the
Shape (Blanking) dialogbox.
5
PAUSE To stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6 STANDBY Standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch
Attention: Switching to Standby. When the projector is running and you want to go to
standby, press the standby key for 2 seconds.
7
MUTE Not used
8 Auto image
Allows to adjust the image automatically ( center the image on the active chip surface).
9 Digit buttons Direct input selection
10 Lens control
Use these button to obtain the desired ZOOM, SHIFT, FOCUS
11
VOL
Not used
12
Picture Controls
Use these buttons to obtain the desired picture analog level
13
DIGI ZOOM
Not used
14 FREEZ Not used
15 PIP Not used
16 ENTER
To c on firm an adjustment or selection in the menu
17
Cursor keys To make menu selections, to perform bare scale adjustments or to zoom/focus when the direct
access is active
36 R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals