7. Advanced
A white bullet indicates the active setting
7.9.6.4 Dynacolor adjustments
Overview
• Introduction
• Calibration for the standard mode (for multiple projectors)
• Common color values
•Infitec common color values
7.9.6.4.1 Introduction
Standard Dynacolor adjustment procedure (multiple projectors)
The adjustment of Dynacolor consists of :
1. Measuring the color values for each projector (Calibration procedure)
2. Calculating the common values filling them in the desired value of every projector
The Infitec Dynacolor calibration can also be done over multiple projectors. Common values must be calcu-
lated and filled in every projector.
In case one uses linked Dynacolor, the master projector will calculate the common values and force them on
all (the linked) slave projectors
7.9.6.4.2 Calibration for the standard mode (for multiple projectors)
What has to be done ?
The calibration of Dynacolor consists of measuring the color values of each projector. The measurements have to be done in a
dark environment. Make sure all external lights are off (even a PC screen can produce too much unwanted light). Use a light
meter (PR655, LMT, …) and at a fixed position during the entire measurement. In the procedure below we consider a system of 2
projectors.
CAUTION: Only to be done by qualified personnel ! Never change the values if not needed. Altered color
values will not guarantee optimal image reproduction.
How to calibrate Dynacolor for projector 1 ?
1. Select Adjust Set1... (see procedure above)
2. Press Calibration in the dialog box
A red test pattern is displayed.
3. Press ENTER
R59770324 SIM 5W 22/12/2011
139
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
