4. Installation
Projector
HUB
To LAN
DVI-D COMPUTER
DVI-D HDCP COMPUTER
Image 4-22
Network connection
The port for ethernet communication is IP port 5401
The linking of projectors is treated in the section “Setup of the linked projectors in a multichannel system”
4.9.9.2 Network settings
CAUTION: Make sure that a DHCP server is available in the network and works fine.
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto five minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
What can be done?
These settings are used to set the Ethernet Communication parameters.
Following parameters are available :
MAC Address MAC Address of the projector (T
his is a non-adjustable value programmed into the Ethernet
board).
IP Address (Current) IP Address of the projector (This is a non-adjustable value).
Subnet Mask Subnet Mask (This is a non-adjustable value)
32 R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
