7. Advanced
Link Infitec Set can only be performed if the linked CLO has been enabled, see Linked Projectors.
7.9.7 Color temperature
What can be done ?
The color temperature can be selected from a list of presets. As a matter of fact, changing the setting of the color temperature is
changing the x and y position of the white point in DynaColor.
There are 4 different preset color temperatures:
•Projectorwhite
• Computer : 9300 K
• Video : 6500 K
• Film : 5400 K
If Disabled is selected, the default Dynacolor white point is selected.
Since Color Temperature basically is a DynaColor setting, linking projectors for Dynacolor will also force the
Color Temperature settings from the master to the slave projectors..
How to select a preset color temperature ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setupitem
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Color temperature
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired preset color temperature
7. Press ENTER
The color temperature of the image is adapted and a bullet shows the active setting.
Image 7-165
7.9.8 Brilliant Color
TM
Mode
What can be done ?
Brilliant Color
TM
(Texas Instruments
TM
technology) allows to use secondary colors in the process of the image (cyan, magenta, and
yellow), resulting in an increase of the color gamut and the overall brightness.
Depending on the type of color wheel, the contribution of the Brilliant Color Mode can be adjusted in 2 or in 4 levels:
R59770324 SIM 5W 22/12/2011
143
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
