Barco SIM 5W - Cleaning the Lens; The Lens Lock Handle Is Located on the Front Side of the Projector, Slide this Handle to the Right

4. Installation
How to remove the Lens?
1. Support the lens with one hand.
2. The lens lock handle is located on the front side of the projector, slide this handle to the right.
Image 4-7
The lens lock handle is located on the front side of the projector, slide this handle to the right.
3. Remove the lens out of its housing.
4. Slide the lens lock handle back to the left.
4.3 Cleaning the lens
To minimize the possibility of damage to optical coatings, or scratches to lens surfaces, we have developed
recommendations for cleaning. FIRST, we recommend you try to remove any material from the lens by blowing
it off with clean, dry deionized air. DO NO
T use any liquid to clean the lenses.
Necessary tools
Tor a y see
TM
cloth (delivered together with the lens kit). Order number : R379058.
Howtocleanthelens?
1. Always wipe lenses with a CLEAN Toraysee
TM
cloth.
2. Wipe lenses in a one single direction.
Warning: Do not wipe back and forwards across the lens s urface as this tends to grind dirt into the coating.
3. Do not leave the cleaning cloth in either an open room or lab coat pocket, as doing so can contaminate the cloth.
4. If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty cloth.
CAUTION: Do not use fabric softener when washing the cleaning cloth or softener sheets when drying the
cloth.
Do not use liquid cleaners on the cloth as doing so will contaminate the cloth.
Other lenses can also be cleaned safe
ly with this Toraysee
TM
cloth.
20 R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals