Barco SIM 5W - Connections; Connections Overview; Power Connection

4. Installation
The configuration should also be communicated to the projector. This is done in the Installation menu through
the Projector Configuration parameter. (See Setup section)
4.9 Connections
Overview
• Power connection
• Connections overview
• Composite video
• S-Video
•RGB
• Component video
•DVI
•PC
• Communications
4.9.1 Power connection
Power specifications
Power input range: 90V - 254V AC / 50–60Hz
Power consumption: 680W
Power cord connection
Use the supplied power cord to connect the projector to the wall outlet. Plug the female power connector into the male connector at
the front left side of the projector.
Projector
DVI-D COMPUTER
DVI-D HDCP COMPUTER
Image 4-11
4.9.2 Connections overview
Connections Overview
The following table gives an overview of the available connections found on the front panel :
24
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals