7. Advanced
Factory preset
Sets the measured parameters back to the factory preset for the current set
Calibration This starts the calibration procedure for the measured points of the current set (Changing the
settings may seriously affect the performance of the projector).
Image 7-159
7.9.6.2 Enabling DynaColor
What can be done ?
Enabling the DynaColor
will change the colors to the desired colors mentioned in the DynaColor menu. Disabling DynaColor will
keep the original colors determined by the source and the projector’s optical path.
How to start up Dynacolor?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Dynaco
lor
5. Press → to open the menu
R59770324 SIM 5W 22/12/2011
137
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
