7. Advanced
7.11.6.1 AutoImage
What can be done ?
AutoImage can be disabled. In case of a new (unknow) source, no automatic file selection will be done. Instead, a more or less
suited file will be selected, resulting in a misaligned image. Image settings must be done manually (edit image file).
How to enable/disable AutoImage ?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select O peration options
5. Press → to pull down the menu
6. Press ↓ to select Autoimage
7. Press → to pull down the menu
8. Use ↑ or ↓ to select On/Off
9. Press ENTER
Image 7-245
A white bullet shows the active setting
7.11.6.2 Warning messages
What can be done?
It is possible to block some Warning messages during projector runtime. The table below gives an overview of those messages that
can be suppressed during runtime.
Warning message
Sim 5W Galaxy NH-12
Galaxy NW-12
Galaxy NW-7
Description
NO SIGNAL
xx
In case no incoming Sync is detected
Lamp error icon
x
In case of an actual lamp or LPS problem
Lamp runtime warning
xx
Max lamp runtime almost reached
Lamp runtime exceeded
xx
Max lamp runtime exceeded
Desktop resolution not valid
x
Desktop input signal resolution is out of
specification.
Wait box
xx
An hourglass icon that is displayed during
processing
For safety reasons, the warning messages Lamp runtime warning and Lamp runtime exceeded will always
pop up during start-up of the projector. They can only be suppressed during projector runtime.
How to enable/disable Warning Messages?
1. Press MENU to activate the Tool bar
R59770324 SIM 5W 22/12/2011
183
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
