7. Advanced
A dialog box is displayed for the red color
Image 7-162
4. Fill out the measured x and y and coordinates and the Y value
Note: theYvaluewillbetransformedinaLvaluebytheprojector
5. Press Next
A green test pattern is displayed
6. Proceed in the same way as you did for the red color
Note: When all colors has been measured and a ll values has been filled out, the D ynacolor m ain dialog box will appear again.
7. The values are finally updated in the measured values of the Dynacolor dialog box.
8. Press Default desired to copy the measured values for red, green and blue and to calculate the secondary colors cyan, yellow
and magenta.
140
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
