Becker RT6201 - Automatic Storage Function; Label (Identifier) Data; Delete Data

Becker Avionics
DV14307.03 Issue 06 February 2021 Transceivers 6200 Series 133
3.6.4.2 Label (Identifier) Data
• Turn the rotary encoder to select the characters.
o The selection works in both directions
(example: blank  A …Z  0  9  —  /  blank  A with a
turn clockwise or counter clockwise).
o A short push on the rotary encoder and the cursor is on the next
position.
o A short push on the "STO" key stores the label.
o A long push on the "STO" key clears the label.
• When the change is stored the transceiver changes to the before
selected mode.
• If no action occurs in label editing mode in 7 seconds, the transceiver
changes to the before selected mode without storage the frequency and
label information.
• Stored frequencies are callable in channel mode (see "Channel Mode
"
page 130).
Automatic Storage Function
The transceiver stores recently selected frequencies. Named and callable as LAST 1…LAST 9
(see "Channel Mode" page 130).
• Whit the change to a new active frequency, the before selected active
frequency is stored in memory as LAST 1.
• The frequencies stored in LAST 1...LAST 8 are shifted to memory
channels LAST 2...LAST 9.
Notice: The functions "LAST" and Store/Restore are only available if they are enabled in
the configuration setup* - (page "MEM OPTIONS").
* (Details see "Configuration Setup" page 69).
3.6.5.1 Delete data
The stored data in the user channel database can only be deleted in the configuration setup*.
Please notice the whole channel database will be reset.
* (Details see "Configuration Setup" page 69).
STO
_ _ _ _ _ _ _ _ _ _
125.875