SENSseries LB 480 Level measurement
BERTHOLD TECHNOLOGIES GmbH & Co. KG
2 – 203
Volume 2 2 Installation
2
2.6.4 Rod Source Cascaded
If several rod sources are needed, the individual parts are arranged
directly on top of each other and fixed with screws.
Multi-part shieldings are in addition marked by the letters A, B, C
etc. from top to bottom (see Fig. 2-27).
Fig. 2-27 Rod source arrangement (multi-part)
Each part must be secured adequately, e.g. by using a flat iron as
anti-tipping device (Fig. 2-28).
Following installation of the shielding, the function of the locking
mechanism has to be tested. The function check has to be carried
out every six months and recorded.
Bracket
Source shielding
(multi-part)
Mounting base
Side view
To Next Page
Loading...
