BERTHOLD TECHNOLOGIES LB 480 - Page 309

3
54733-10BA2L
3 – 309 02.2017
Quick Start
Sensor Configuration
Signal Condition
...
...
...
Setup
page 3-316
Step 1 Step 2 Step 3
Date
Time
Time Constant
Nuclide
ReadIn Time
Read In
Background
Cal Point 0%
Cal Point 100%
Calibrate + Preset
Quick Start, page 3-317
page 3-319
page 3-318
page 3-317
Sensor Configuration, page 3-322
Date & Time
Date
Time
Active Detector No.
Sensor Settings
Active Detector No.
Error Code
Detector Device Id
Detector Code
HV Mode
HV Live
HV Average
HV Manual
HV Default
Cps Single Detector
page 3-323
page 3-324
Config Slave Detectors
Nbr of Slaves
Add Slave
Remove Slave
Refresh Slave Table
Detector Table
page 3-327
Signal Condition, page 3-328
Signal Parameter
Time Const
Error Handling
Set Error Handling
Signal Unlocked
PRC Comp Factor
GPC Comp Factor Limit
Lower Range Value
Upper Range Value
% Meas Range
Response Mode
Io Factor
Waiting Time
RI Sigma
Meas Delay Time
RS Sigma
Selection
Warning Date
Max Reading Fluctuation
Reading Range Signal Dependency Source Exchange
page 3-329
page 3-330
page 3-331
page 3-333
The parameters shown in gray type appear only in
certain settings.
Please refer to the respective parameter description.