BERTHOLD TECHNOLOGIES LB 480 - Page 310

Volume 3
...
...
...
Cal Parameter
I/O Setup
Service
Setup
page 3-316
Cal Parameter, page 3-335
Cal Settings
Nuclide
Calibration Method
Cal Curve Type
ReadIn Time
Measuring Path
Product Density
Compensation Mode
Gas measuring path
Setup Gas Density
Gas Density at Op
ReadIn
Background
Background Comp
Cal Point No.
Cal Level
Cal Rate
Cal Rate Comp
Cal Rate at Op
Sort
Calibration Chart
Product ConditionsCal Points
page 3-341
page 3-343
page 3-337
Calibrate
Recall
page 3-336
page 3-337
Adapt Calibration
ReadIn
Comp Table Index
Cps Level
Cps Density
Calculate Factor
Comp Factor
Cal Rate Comp Table
Calc Comp Factor
page 3-349
Adjust Lower Point
(page 3-351)
Adjust Upper Point
(page 3-353)
Restore Upload
Restore Date
page 3-350
I/O Setup, page 3-354
Current Output
Current Loop Monitoring
Loop Alarm Type
Error Current Value
Current Lower Limit
Current Upper Limit
D/A trim
Digital Input HART Interface
Digital In Function
Digital In State
Poll Addr
Set Poll Addr
Num Req Preams
Num Resp Preams
page 3-355
page 3-361
page 3-362
Digital Output, page 3-357
Digital Out Function
page 3-357
Level Threshold Settings
Switch Function
Threshold
Hysteresis
page 3-359
Temp. Threshold Settings
Temp. Upper Limit
Temp. Lower Limit
Temp. Hysteresis
Temp. Unit
Device Temp.
page 3-360
Digital Out State
page 3-358
Service
PMT
Sensor Temperature
Test
Plateau
License Key
Reset Device
page 3-363
continued on page
3-312
The parameters shown in gray type appear only in
certain settings.
Please refer to the respective parameter description.