BERTHOLD TECHNOLOGIES LB 480 - Page 8

54733-10BA2L
1 – 8 02.2017
Table of Contents Volume 1-3
Volume 3 Operation with
HART
®
Communicator
1 HART
®
Communication .................................................. 3 – 301
1.1 HART® Protocol ..................................................... 3 – 301
1.2 General Information on the
HART
®
Communicator ........................................... 3 – 301
1.3 Connection, Power On and Power Off of the
HART
®
Communicator ........................................... 3 – 302
1.4 Working with the HART
®
Communicator ............... 3 – 302
1.5 Archiving Parameter Sets........................................ 3 – 303
2 Menu Structure .............................................................. 3 – 307
2.1 Information on the Menu Structure ........................ 3 – 307
2.2 Menu Overview...................................................... 3 – 308
2.3 Start Menu............................................................. 3 – 313
2.4 Live Display.......................................................... 3 – 314
2.5 Device Config....................................................... 3 – 316
2.6 Setup .................................................................... 3 – 316
2.7 Quick Start ........................................................... 3 – 317
2.8 Quick Start, Step 1................................................. 3 – 317
2.9 Quick Start, Step 2................................................. 3 – 318
2.10 Quick Start, Step 3................................................. 3 – 319
2.11 Sensor Configuration .......................................... 3 – 322
2.12 Date & Time ......................................................... 3 – 323
2.13 Sensor Settings.................................................... 3 – 324
2.14 Config Slave Detectors........................................ 3 – 327
2.15 Signal Condition .................................................. 3 – 328
2.16 Signal Parameter ................................................. 3 – 329
2.17 Reading Range..................................................... 3 – 330
2.18 Signal Dependency.............................................. 3 – 331
2.19 Source Exchange.................................................. 3 – 333
2.20 Cal Parameter....................................................... 3 – 335
2.21 Cal Points.............................................................. 3 – 337
2.22 Cal Settings .......................................................... 3 – 341
2.23 Product Conditions.............................................. 3 – 343
2.24 Calc Comp Factor ................................................. 3 – 349
2.25 Adapt Calibration ................................................ 3 – 350
2.26 Adjust Lower Point.............................................. 3 – 351
2.27 Adjust Upper Point.............................................. 3 – 353